Hornady Lock-n-Load AP die bushing loosening

[wwillson]

All,

I have a Hornady Lock-n-Load AP, which has proved to be a great press for me. I do have a rather annoying problem though with a die bushing that won't stay tight in the press. While loading this past weekend I started having a problem that about every 50th round, the die bushing holding the 9mm taper crimp die would loosen. If I didn't notice the bushing starting to loosen, by seeing the die move slightly, then the die would completely loosen and pop all the way up in the press.

Does anyone know how to keep the die bushings from loosening?

Thanks,

Wayne

[Tom]

I make sure to tighten them until they are fully seated, usually with a wrench. I broke a bushing when it came a little loose and I was neck sizing rifle cartridges.

[Crashbox]

I definitely need to visit here more often!

I use Teflon ® plumber's tape on the bushing- just a couple of wraps around it seems to work wonders. I believe Hornady makes a Belleville washer to prevent this as well, I think if you call them they'll send one or two at no or minimal cost.

[wwillson]

Crashbox,

Teflon tape is a great idea! I have some in the drawer beside my press, but didn't think of it.

Thank You,

Wayne